CentOS Linux 7 主機已安裝的套件會受到 TuxCare CENTOS7：CLSA-2026：1792234299 公告中提及的多個弱點影響。

  - 在 Linux 核心 5.18.14 以及之前版本中，net/netfilter/nfnetlink_queue.c 中的 nfqnl_mangle 允許遠端攻擊者造成拒絕服務 (錯誤)，這是因爲當 nf_queue 判定包含一個位元組的 nfta_payload 屬性時，skb_pull 可能遇到負數 skb->len。(CVE-2022-36946)

  - 已解決 Linux 核心中的下列弱點：wifi: iwlwifi: mvm: Fix a memory corruption issue A few lines above, space is kzalloc()'ed for: sizeof(struct iwl_nvm_data) + sizeof(struct ieee80211_channel) + sizeof(struct ieee80211_rate) 'mvm->nvm_data' is a 'struct iwl_nvm_data', so it is fine. At the end of this structure, there is the 'channels' flex array. Each element is of type 'struct ieee80211_channel'. So only 1 element is allocated in this array. When doing:
    mvm->nvm_data->bands[0].channels = mvm->nvm_data->channels; We point at the first element of the 'channels' flex array. So this is fine. However, when doing: mvm->nvm_data->bands[0].bitrates = (void
    *)((u8 *)mvm->nvm_data->channels + 1); because of the (u8 *) cast, we add only 1 to the address of the beginning of the flex array. It is likely that we want point at the 'struct ieee80211_rate' allocated just after. Remove the spurious casting so that the pointer arithmetic works as expected. (CVE-2023-52531)

  - 已解決 Linux 核心中的下列弱點：KVM: x86: Don't (re)check L1 intercepts when completing userspace I/O When completing emulation of instruction that generated a userspace exit for I/O, don't recheck L1 intercepts as KVM has already finished that phase of instruction execution, i.e. has already committed to allowing L2 to perform I/O. If L1 (or host userspace) modifies the I/O permission bitmaps during the exit to userspace, KVM will treat the access as being intercepted despite already having emulated the I/O access. Pivot on EMULTYPE_NO_DECODE to detect that KVM is completing emulation. Of the three users of EMULTYPE_NO_DECODE, only complete_emulated_io() (the intended recipient) can reach the code in question. gp_interception()'s use is mutually exclusive with is_guest_mode(), and complete_emulated_insn_gp() unconditionally pairs EMULTYPE_NO_DECODE with EMULTYPE_SKIP. The bad behavior was detected by a syzkaller program that toggles port I/O interception during the userspace I/O exit, ultimately resulting in a WARN on vcpu->arch.pio.count being non-zero due to KVM no completing emulation of the I/O instruction. WARNING: CPU: 23 PID: 1083 at arch/x86/kvm/x86.c:8039 emulator_pio_in_out+0x154/0x170 [kvm] Modules linked in: kvm_intel kvm irqbypass CPU: 23 UID: 1000 PID: 1083 Comm: repro Not tainted 6.16.0-rc5-c1610d2d66b1-next-vm #74 NONE Hardware name: QEMU Standard PC (Q35 + ICH9, 2009), BIOS 0.0.0 02/06/2015 RIP: 0010:emulator_pio_in_out+0x154/0x170 [kvm] PKRU: 55555554 Call Trace: <TASK> kvm_fast_pio+0xd6/0x1d0 [kvm] vmx_handle_exit+0x149/0x610 [kvm_intel] kvm_arch_vcpu_ioctl_run+0xda8/0x1ac0 [kvm] kvm_vcpu_ioctl+0x244/0x8c0 [kvm]
    __x64_sys_ioctl+0x8a/0xd0 do_syscall_64+0x5d/0xc60 entry_SYSCALL_64_after_hwframe+0x4b/0x53 </TASK> (CVE-2025-40026)

  - 已解決 Linux 核心中的下列弱點：Bluetooth: btusb: fix use-after-free on registration failure Make sure to release the sibling interfaces in case controller registration fails to avoid use-after-free and double-free when they are eventually disconnected. This issue was reported by Sashiko while reviewing a fix for a wakeup source leak in the btusb probe errors paths. (CVE-2026-64471)

  - 已解決 Linux 核心中的下列弱點：ALSA: firewire: isight: bound the sample count to the packet payload isight_packet() takes the frame count from the device iso packet and checks it only against the device claimed iso length. count = be32_to_cpu(payload->sample_count); if (likely(count <= (length - 16) / 4)) isight_samples(isight, payload->samples, count); length is the iso header data_length. It can be up to 0xffff. So the gate allows a count up to about 16379. isight_samples() then copies count frames out of payload->samples into the PCM DMA buffer. payload->samples holds only 2 * MAX_FRAMES_PER_PACKET values. The device multiplexes two samples per frame. A count past MAX_FRAMES_PER_PACKET reads past the payload. A count past the buffer size writes past runtime->dma_area.
    The smallest PCM buffer is larger than MAX_FRAMES_PER_PACKET. Bounding the count to MAX_FRAMES_PER_PACKET keeps both the read and the write in range. A malicious or faulty Apple iSight on the FireWire bus reaches this during a normal capture. Add the MAX_FRAMES_PER_PACKET bound to the gate. (CVE-2026-64483)

請注意，Nessus 並未測試這些問題，而是僅依據應用程式自我報告的版本號碼作出判斷。

偵測

CentOS Linux 7 [TuxCare] 安全性更新：bpftool / kernel / kernel-debug / kernel-debug-devel / kernel-devel / etc 多個弱點（CENTOS7：CLSA-2026：1792234299）

high Nessus Plugin ID 369489

版本 1.1

偵測

CentOS Linux 7 [TuxCare] 安全性更新：bpftool / kernel / kernel-debug / kernel-debug-devel / kernel-devel / etc 多個弱點 （CENTOS7：CLSA-2026：1792234299）

high Nessus Plugin ID 369489

版本 1.1

CentOS Linux 7 [TuxCare] 安全性更新：bpftool / kernel / kernel-debug / kernel-debug-devel / kernel-devel / etc 多個弱點（CENTOS7：CLSA-2026：1792234299）